Software Update - HELIX 12 CHIRP SI GPS v.1.900

Released 02-06-2019

Software Description

General Fixes:

SONAR:

  • Fixed several issues with 2D Sonar digital depth tracking.
  • Fixed an issue with 2D Sonar performance on ICE HELIX models.
  • Fixed an issue where the “check/enter key” would not change frequencies on sonar views.

360 IMAGING:

  • Fixed an issue where 360 would not connect and display data in a timely manner.
  • Fixed an issue where 360 sensitivities less than 10 did not change the 360 sensitivity setting.

i-PILOT LINK:

  • Fixed an issue where HELIX would reboot when i-Pilot Link connected if the HELIX was updated with i-Pilot Link Auto-Upload Nav Data turned on.

CHART:

  • Fixed a HELIX issue where heading data from the i-Pilot Link was not turning off correctly when the i-Pilot Link motor was stowed.

SYSTEM:

  • Fixed an issue where updating from software older than 1.400 to new software would cause an update issue.

Software Prerequisites

You will need:

  • a working Micro SD reader/writer device attached to your PC and
  • formatted 32GB or smaller Class 10 or MMC/SD card

Instructions

Please read carefully before proceeding.

We highly recommend that you RESTORE the defaults on your unit BEFORE you perform any software update.

How to Restore Defaults:

With the unit powered on, Press the MENU button twice to the main menu on the system. Then you press the RIGHT cursor until you get to the SETUP menu tab. Once you have reached the SETUP menu tab, use the DOWN cursor until you reach RESTORE DEFAULTS, you will then press the RIGHT cursor key to restore the defaults. To confirm press RIGHT cursor again.

To update with an SD CARD

  1. After thoroughly reading these instructions, you can return to the Download dialogue box and click on Download. The software files are in a .bin format. You will not be able to open these files, they should only be saved.
  2. You will need to select to save this file to the SD Card. (The SD card may be listed as a removable disk, removable storage drive, SD). Do not modify the name of the file, then click on SAVE.
  3. After the Download Complete dialog box appears - click CLOSE
  4. Remove the SD Card from the card reader. After removing the SD card from the reader and before powering on the unit, we recommend that you disconnect any Advanced Accessories connected to the unit. This might include a GPS receiver, Interlink, Cannonlink, etc. Also remove any SD or micro cards already inserted on your unit.
  5. POWER ON YOUR UNIT, allow the unit to go through the complete start up BEFORE pressing any buttons or selecting any menu options. After the unit has completed the loading process and you have clicked through the warnings and information, place the SD card in the unit.
  6. You will get a message on the unit saying SOFTWARE NUMBER “123” is higher than your current “120” software do you want to update?, Press the Right Cursor to Confirm.
  7. Another message will then appear saying do you want to ABORT, press the Left Cursor to NO at this time and the software update will begin. DO NOT POWER OFF THE UNIT DURING THIS TIME. If you lose power to the unit during the software upgrade process, it is very likely that the unit will need to be returned to the factory for updating.

Once the update is complete the unit will restart and say current SOFTWARE NUMBER “123” installed, no update required. It is now safe to remove the SD Card, and power off the unit.  

Click here to view a short video on this subject

 

DOWNLOAD